Houston Heat Pump Installation & Replacement

Heat pumps work best in moderate climates but can be effective in colder areas with a proper setup. Homes with good insulation and existing ductwork are ideal candidates. A professional can assess your home’s size, layout, and energy needs to confirm compatibility.

Heat pumps offer both heating and cooling, making them an energy-efficient all-in-one solution. They typically use less electricity than traditional systems and can lower your utility bills. Plus, modern models are quiet, reliable, and environmentally friendly.

Most installations take one to three days, depending on the complexity of your home’s layout and whether you’re replacing an old system. If ductwork or electrical upgrades are needed, the project may take longer. Your contractor will provide a timeline after an initial assessment.

Not always—if your existing ductwork is in good condition and properly sized, it may be reused. However, worn-out or leaky ducts can reduce your system’s efficiency. A technician will inspect your ducts and recommend repairs or upgrades if needed.

The right size depends on your home’s square footage, insulation, window placement, and climate. An HVAC professional will perform a load calculation to determine the correct system size. An oversized or undersized unit can cause performance and efficiency issues.

Installation costs typically range from $4,000 to $10,000, depending on the type of heat pump, your home’s layout, and whether ductwork is involved. While the upfront cost can be higher than a furnace or AC alone, energy savings over time often offset the investment. Incentives or rebates may also be available.

The crew will remove old equipment if needed, set up the indoor and outdoor units, connect wiring and refrigerant lines, and test the system. Expect some noise and foot traffic around your home. At the end, your technician will walk you through the system and show you how to use your new thermostat.

Yes, most local jurisdictions require permits for heat pump installation to ensure electrical and mechanical work is up to code. Your HVAC contractor will typically handle the permitting process. Inspections may also be required before and after the work is completed.